double cardan (CV) drive shaft.
Posted: Fri Jul 16, 2010 9:08 pm
Tom Woods double cardan rear drive shaft. Used but in very good condition. I bought it and never installed it. Made for TJ wranglers. 150.00
obo
obo
Page 1 of 1
Posted: Sat Jul 17, 2010 5:11 am
I'll take it! How long is it?
Posted: Sat Jul 17, 2010 9:53 am
ill check today and let know
Posted: Sun Jul 18, 2010 1:15 pm
Thanx Dale! 
Posted: Mon Jul 19, 2010 5:35 pm
If it was for dales jeep, it should work for you dave.
Posted: Mon Jul 19, 2010 6:23 pm
Does not seem to fit on the fixed yoke that came with my SYE kit. I think Rubi's have bigger u-joints on the DC end. Going to make a call and see if PORC can swap my yoke for a Rubi one. 
Posted: Mon Jul 19, 2010 8:24 pm
TJDave wrote:Does not seem to fit on the fixed yoke that came with my SYE kit. I think Rubi's have bigger u-joints on the DC end. Going to make a call and see if PORC can swap my yoke for a Rubi one.
You have a rubicon, or the shaft is made to fit a rubicon?
Posted: Mon Jul 19, 2010 8:32 pm
mattawajeep wrote:TJDave wrote:Does not seem to fit on the fixed yoke that came with my SYE kit. I think Rubi's have bigger u-joints on the DC end. Going to make a call and see if PORC can swap my yoke for a Rubi one.
You have a rubicon, or the shaft is made to fit a rubicon?
He's putting a Rubicon rear axle in a non-Rubicon Jeep.
Posted: Mon Jul 19, 2010 8:57 pm
Can you use an adapter-type u-joint to fix the problem? Napa has quite a few in stock.
Posted: Tue Jul 27, 2010 8:58 pm
This driveshaft is still up for grabs. It will not work with my NP231 SYE yoke for 1310 u joints. A conversion joint is possible on the axle joint for my set up, but not in the double cardon joint itself.
It will, however, work just dandy in a Rubicon, and could save someone alot of money. Just not me.
It will, however, work just dandy in a Rubicon, and could save someone alot of money. Just not me.