Page 1 of 1
dana 60 crossover arm
Posted: Wed Sep 22, 2010 10:47 am
by 79chevy39.5's
got a unit i built out of 1/2 plate holes drilled then i milled the factory dust cover and tigged it on the whole for the drag link is 6" from center (chevy pitman arm 2wd) decent unit sold the truck i was hoping to use it on
$40 bucks
across the street from trashes place if anyone wants to sneak a peek or pick it up
Posted: Wed Sep 22, 2010 10:51 am
by White trash
Hmm I might have to take a gander, the ferd has a bad case of the death wobbles and the steering stuff is getting worn. I already have the tie rod covered but needed a way to hoop up the drag link... I'll take a look when I get home friday.
Posted: Wed Sep 22, 2010 11:27 am
by 79chevy39.5's
itll be here may have landed a job finally
Posted: Wed Sep 22, 2010 11:35 am
by White trash
As a fluffer at the out & about?
Posted: Wed Sep 22, 2010 12:28 pm
by Grumpy
White trash wrote:As a fluffer at the out & about?
You enjoy a good show and ya know it
Posted: Wed Sep 22, 2010 12:46 pm
by 79chevy39.5's
couldnt be that lucky trash......fleet tech at blue star hopefully and then tri-city battery is interested as well
Posted: Wed Sep 22, 2010 7:51 pm
by Wrench
Broadmoor RV is looking for a good tech and paint guy since the last one left...
