Page 1 of 1
WTB: NP231. I know. . .Irony.
Posted: Sun Oct 16, 2011 7:31 pm
by OldGreen
Popcorn needs a new tcase. . .
Dale? You gonna have an extra? Anyone?
Mine chain is stretched. . .
Posted: Sun Oct 16, 2011 7:36 pm
by Toolegit86
Should have got mine lol... I have another one i can get if needed..
Posted: Sun Oct 16, 2011 7:39 pm
by OldGreen
Seriously. I have a few bucks for a 23 spline version that has a tight chain. . .
LMK. Dale, of course, is an obvious choice since I know he's got two.
Posted: Sun Oct 16, 2011 7:56 pm
by mattawajeep
Uh oh.
I was going to take the shaft out of the cherokee case and stick it into mine as I know it's good. If mick can't get that other one I can go back to the old plan of chopping down my input shaft and give you the cherokee case.
Posted: Sun Oct 16, 2011 7:59 pm
by OldGreen
I'll be rolling through Mattawa next weekend, so either way works!!
Mick, lemme know!!
Posted: Tue Oct 18, 2011 11:53 am
by OldGreen
Dale, I have a fantastic idea. . .why don't you swap out your input bearings and I'll take the leftover case? I can pick it up on Sunday morning and even throw you a little scratch for the effort?
Mick. . .did you get word on the one you had a line on? Sorry to be impatient, but, as you may know, I enjoy a little lunch time wheelin' now and again. Starting to get a little jittery. . .
Posted: Tue Oct 18, 2011 12:12 pm
by SquirrelCrusher
I bought a craigslist transmission that came with a transfer case attached. I might be able to be talked out of the case. I don't know much about it though. 96 cherokee that had an engine fire.
Posted: Tue Oct 18, 2011 3:51 pm
by OldGreen
And. . .BOUGHT. Thank you squirrel crusher!!
Posted: Tue Oct 18, 2011 4:24 pm
by SquirrelCrusher
No problem. You forgot to take the guinea babies. They are free with the purchase of a transfer case
Posted: Tue Oct 18, 2011 5:26 pm
by mattawajeep
Glad you found one - I've been looking at takedown instructions all day to see how hard they are to get apart. Looks like the whole thing has to be in pieces to remove the input shaft. Don't know if I could got it figured out by this weekend.
Posted: Tue Oct 18, 2011 5:30 pm
by White trash
mattawajeep wrote:Glad you found one - I've been looking at takedown instructions all day to see how hard they are to get apart. Looks like the whole thing has to be in pieces to remove the input shaft. Don't know if I could got it figured out by this weekend.
It's been awhile since I've had one apart but I think you can pull the input gear once the input retainer is removed from the rest of the case.