does this work?

[Roman]

was doing some google research (wandering) and found this page about using Dodge D44 hub and rotor on chevy D44 large spindle to convert to 5x5.5

http://panther4x4.com/Scrambler/Dana44/index.html

if so, what year dodge should I start fleecing?

[Lurch]

I used a ford rotor and hub/bearings off any ford d44 on the chevy large spindle.

[OldGreen]

I used a ford rotor and hub/bearings off any ford d44 on the chevy large spindle.

That's what I did. I think I specified a 1979 F150 for the parts dorks at schucks.

[tobyw]

You found it on the innernetz. It HAS to work.

[Roman]

I used a ford rotor and hub/bearings off any ford d44 on the chevy large spindle.

I thought you had to use the chevy small spindle or machine the large one to take the small inner bearing

[bobracing]

I used a ford rotor and hub/bearings off any ford d44 on the chevy large spindle.

I thought you had to use the chevy small spindle or machine the large one to take the small inner bearing

X2
Chevy small bearing spindle bearings with a Ford rear spindle seal.

http://www.pirate4x4.com/forum/showthread.php?t=313792

[Lurch]

Now that I think about it I think it was the small spindle.

[OldGreen]

yep yep. . .that's right. . .

So. . .the dodge stuff. . .huh. . .awesome. . .