PEAK PUTTERS

After an unsuccessful hunt for bungs, I dug out my grandpa's tap and die set to make my own. Here are a few pictures for giggles. I'm using a 7/8" tap and 3/4" tube to make these bungs. I also added a bit more thread to the 7/8" bolts that I using.




This shot is of a bung clean out after the bung insertion

i needed a 3/8 bung for my on board air and ended up cutting a 3/8 coupler in 1/2

not pipe bung . . .

Tube adapter!

Roman wrote:not pipe bung . . .

Tube adapter!

Funny how the correct terminology makes just a little bit of a difference.