Wanted: Chevy trans parts

[Wrench]

Hey guys,
my '85 Chevy 700r4 took a dump when a friend borrowed it a few months ago. I plan to replace it with an SM465/NP205 combo I have on hand, and need parts for the conversion.

Looks like I need:
-clutch pressure plate and disk
-clutch pedal and linkage assembly
-possibly drive lines if they are not the right length

I would also like to ditch the original non-tilt steering column with the auto shifter on it for a tilt-model without the shifter.

If you know of any other items needed for this conversion or have any of these parts you would like to sell, please let me know.

[79chevy39.5's]

if your using a hydraulic system(not the mechanical) make sure to use a diaphragm clutch not the 3 finger ones as they will not work, i fought that the whole way when i converted my 79 from turbo 400 to sm465

[Wrench]

if your using a hydraulic system(not the mechanical) make sure to use a diaphragm clutch not the 3 finger ones as they will not work, i fought that the whole way when i converted my 79 from turbo 400 to sm465

I plan to use whatever stock setup Chevy had for a clutch in '85. As far as I know, those were all cable/mechanical?

[79chevy39.5's]

i dont know when they went to hydraulic but my 88 one ton (truck i got my dana 60 from had hydraulic)